Brother BAS-343E Instruction Manual page 55

11. Changing special functions using the memory switches
•¡ Memory Switches (10 •` 1F)
SW No.
memo-10
memo-11
memo-12
memo-13
memo-14
memo-15
memo-16
memo-17
memo-18
memo-19
memo-1A
memo-1b
memo-1c
memo-1d
memo-1E
memo-1F
•¡ Memory Switches (20 •` 2F)
SW No.
memo-20
memo-21
memo-22
memo-23
memo-24
memo-25 memo-2F
48
Milling device can be used (available as an option)
Bobbin thread counter and production counter are adjusted when thread is trimmed
Work clamp is lowered by pressing work clamp first stage switch twice, without using work
clamp second stage switch. When DIP switch A-2 is ON, work clamp lowers in the order
right left; when OFF, work clamp lowers in the order left right. Order is opposite when rising.
When work clamp is lowered, the starting switch causes locking; if the switch is released
before locking, the work clamp rises
When DIP switch A-2 is ON, work clamp lowers in the order right left; when OFF, work
clamp lowers in the order left right. Order is opposite when rising
ON when machine is equipped with signal tower indicator. (This indicator is available by special order.)
ON when machine is equipped with thread nipper. (Thread nipper is available by special order.)
ON when machine is equipped with reset switch. (Reset switch is available by special order.)
When using a triple pedal (DIP switch B-7 is also ON), the right is used exclusively to detect
the home position. If DIP switch A-7 is OFF, the left pedal causes left and right work clamps
to be raised and lowered simultaneously. If ON, the left pedal causes the left work clamp to be
raised and lowered, and the right work clamp lowers when starting pedal to sew
B430E single foot pedal can be used. DIP switch A-7 is ON.
Bobbin thread counter is decremented at the start of sewing.
When using an air pressure drop detection switch. (This detection switch is available by special order.)
Program number is changed automatically
During feed test operation, feeding 100 stitches at a time is possible using the STEP
BACK switch.
After the home position is detected and the machine moves to the sewing start position,
the work clamp rises automatically.
When extended option output No. 1 is ON, the sewing machine starts automatically.
Set to ON when the bobbin changer is being used. (This part is available by special order.)
Sewing operations are carried out even if the cassette detection sensor is off.
When ON
Needle up error detected.
Split number is changed automatically
When ON
BAS-343E