Brother BAS-343E Instruction Manual page 23

6. Panel operation
PROGRAM NO. PROGRAM NO.
R / W
! 0 Bobbin Thread COUNTER .... Illuminates when bobbin thread counter mode has been selected using the
indicator ................................. menu switch y.
! 1 SPLIT NO. indicator ............... Illuminates when split No. mode has been selected using the menu switch y.
! 2 Dial ......................................... The setting shown on the display screen t can be changed by turning this dial
! 3 Bobbin Thread SET switch .... Used to store the number of work pieces displayed in the bobbin thread counter
! 4 Bobbin Thread CHANGE ....... Used to continue sewing after replacing the bobbin thread.
switch
! 5 TEST switch ........................... Used to move the feed mechanism only in order to confirm a programmed
! 6 TEST indicator ....................... Lights when the TEST switch is pressed.
!7 STEP BACK switch ................ Used when winding a fresh bobbin, or when correcting a stitch pattern due to
16
BAS-300E series
MENU
X - SCALE
Y - SCALE
SPEED
!0
B.T. COUNTER
!1
SPLIT N .
y
while pressing the STEP BACK switch !7 .
to floppy disk.
(An alarm will sound when the counter reads <000>. Sewing is not possible
when the counter reads <000>.) (Refer to "6-9. Using the bobbin thread
counter".)
stitch pattern.
a broken needle thread.
t
B.T. SET
TEST
!2 !5
BAS-343E
POWER
B. B.T. CHANGE . CHANGE
!3
!4
STEP BACK
!6
!7