Error Codes - Brother BAS-343E Instruction Manual

12. Error codes

12. Error codes
NOTE
• If an operation problem occurs, a buzzer will sound and an error code will appear on the display screen; if a
programmer is connected, an error message will appear on the screen.
• Wait 10 seconds or more after turning the power off before turning it back on again.
Code
E.10
Emergency stop switch was pressed.
E.11
Emergency stop switch was pressed during
sewing.
Emergency stop switch is being continually pressed,
E.12
or emergency switch connection error.
E.20
Problem with machine motor stopping, or
synchronizer connection error.
E.21
Machine motor operation error.
E.22
Needle up stop position error.
E.30 Data is outside possible sewing area due to
enlargement or reduction ratio setting.
Data pitch exceeds 12.7 mm due to enlargement
E.31
or reduction ratio setting.
E.32 No end code was input into sewing data.
E.40
Floppy disk is not inserted, disconnected cord
inside operation panel, or malfunction of drive.
E.41
Program number is invalid, no data, or floppy disk
is not formatted.
E.43
Floppy disk changed from readable disk when setting
the bobbin thread or when setting the memory switch.
E.4F Other error when reading floppy disk.
Floppy disk is write-protected.
E.50
Insufficient space on floppy disk.
E.51
E.52 Floppy disk cannot be formatted
Floppy disk write error.
E.5F
Data backup is not possible.
E.60
Data cannot be backed up
E.61
Overlapping option output numbers.
E.70
E.80
Thread breakage error detected by rotating-type
thread breakage detector device.
E.81
Upper thread breakage error detected by optical
fiber-type sensor.
50
Cause
BAS-343E
Remedy
Press the emergency stop switch once more to cancel.
Press the emergency stop switch once more to cancel.
The STEP BACK switch can then be used to resume
sewing.
Turn off the power and check.
Turn off the power, and then turn the machine pulley
to check if the machine has locked up. Check the
synchronizer connection. Check if connectors P14,
P15 or P16 are disconnected.
Turn off the power and check the ground wire
connection.
Turn the pulley to align the index mark with the needle
up stop position. Check the V-belt tension.
Check the enlargement or reduction ratio setting.
Check the enlargement or reduction ratio setting.
Input an end code, or change the program number.
Insert a floppy disk. If floppy disk is already inserted,
turn off the power and check the connections of cords
inside the operation panel.
Check the floppy disk.
Replace with a readable floppy.
Replace the floppy disk annd repeat the operation.
Remove the write-protection.
Use a different floppy disk.
Replace the floppy disk and repeat the operation.
Repeat the operation.
Turn off the power, wait a while and then turn it back
on. If the error appears continually, contact a qualified
service technician.
Change the option output number.
Thread the upper thread. Sewing can then resume.
Thread the upper thread. Sewing can then resume.