Fan/Air Baffle - HP 5850 - Deskjet Color Inkjet Printer Reference Manual

Fan/Air Baffle

1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Unplug the fan cable from the system board (CHFAN, P9).
4. Remove the processor baffle.
5. Remove the silver T15 screw that secures the baffle to the base of the chassis.
6. Unplug the speaker cable.
7. Push down on the two top tabs that secure the baffle to the front of the chassis (1), and then push
the two bottom tabs toward each other (2).
8. Slide the baffle about 1 inch (2.5 cm) toward the rear of the unit, and then lift the baffle up and out
of the chassis while threading the speaker cable through the hole on the side of the baffle.
To reinstall the fan/air baffle, reverse the removal procedure.
When reinstalling the baffle, be sure to thread the speaker cable back through the hole in the side of
the baffle, and then plug the cable back into the system board.
94 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
61).
66).