Fan - HP ProDesk 600 G5 Maintenance And Service Manual

Fan

1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the fan cable from the system board (1).
4. Remove the fan cable from the clips on the side of the heat sink (2).
5. Lift fan up to about 30-45 degrees (3), and then pull it away from the heat sink (4).
To install the fan, reverse the removal procedure.
30 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page 15).
14).