Fan Shroud - HP ProDesk 600 G4 SFF Maintenance And Service Manual

Fan shroud

Follow these steps to remove the fan shroud:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the front bezel (see
4. Remove the drive cage (see
Remove the fan shroud:
1. Position the computer with the rear panel toward you.
2. Disconnect the power supply P3 (1) cable from the system board.
3. Release the power supply P3 cable from the retention clips built into the fan shroud (2).
4. Press out on the fan shroud release tabs (3).
5. Remove the fan shroud (4).
Reverse this procedure to install the fan shroud.
38 Chapter 4 Removal and replacement procedures
Preparation for disassembly on page
Access panel on page 29).
Front bezel on page 31).
Drive cage on page 34).
28).