Power Switch/Led Assembly - HP 5850 - Deskjet Color Inkjet Printer Reference Manual

Power Switch/LED Assembly

1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Remove the processor baffle
5. Remove the fan/baffle
6. Disconnect the cable from the system board (P5, PB/LED).
7. Press on the left side of the assembly and rotate away from the chassis while threading the cable
between the drive cage and the front of the chassis, then through the hole in front of the chassis.
8. Remove the assembly from the chassis.
To reinstall the assembly, insert the tabs on the right side of the assembly into the slots in the chassis,
and then rotate the left side of the assembly down until it snaps into place.
96 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
(Front Bezel on page
(Processor Baffle on page
(Fan/Air Baffle on page
67).
93).
94).
61).
66).