HP 5850 - Deskjet Color Inkjet Printer Reference Manual page 52

Use the following utilities to manage security settings on the HP computer:
●
Locally, using the Computer Setup Utilities. See the Computer Setup (F10) Utility Guide included
with the computer for additional information and instructions on using the Computer Setup Utilities.
Some computers also have HP BIOS Configuration for ProtectTools, which is a Windows-based
component of ProtectTools that allows administrators to configure BIOS security settings from
within the running OS.
● Remotely, using HP Client Manager, HP Client Configuration Manager, or System Software
Manager. This software enables the secure, consistent deployment and control of security settings.
The following table and sections refer to managing security features of the computer locally through the
Computer Setup (F10) Utilities.
Table 4-1 Security Features Overview
Option
Setup Password
Power-On Password
Password Options
(This selection will appear only if a
power-on password is set.)
Pre-Boot Authorization
Smart Cover (some models)
Embedded Security
Device Security
40 Chapter 4 Desktop Management
Description
Allows you to set and enable setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup
options, flash the ROM, and make changes to certain plug and play settings
under Windows.
See the Troubleshooting Guide for more information.
Allows you to set and enable power-on password. The power-on password
prompt appears after a power cycle. If the user does not enter the correct
power-on password, the unit will not boot.
NOTE: This password does not appear on warm boots, such as
+Delete or Restart from Windows, unless enabled in Password Options,
below.
See the Troubleshooting Guide for more information.
Allows you to specify whether the password is required for warm boot
+Alt+Del).
See the Troubleshooting Guide for more information.
Allows you to enable/disable the Smart Card to be used in place of the Power-
On Password.
Allows you to:
● Enable/disable the Cover Lock.
●
Enable/disable the Cover Removal Sensor.
NOTE: Notify User alerts the user that the sensor has detected that the
cover has been removed. Setup Password requires that the setup password
be entered to boot the computer if the sensor detects that the cover has been
removed.
Allows you to:
●
Enable/disable the Embedded Security device.
● Reset the device to Factory Settings.
This feature is supported on some models only. See the HP ProtectTools
Security Manager Guide at http://www.hp.com
Enables/disables serial ports, parallel port, front USB ports, system audio,
network controllers (some models), and SCSI controllers (some models).
Ctrl+Alt
(Ctrl