Ti Over Fcr Example - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Host 1
8
5
Edge fabric 1
Domain ID = 4
= Dedicated path set up by TI zone in edge fabric 1
= Dedicated path set up by TI zone in edge fabric 2
= Dedicated path set up by TI zone in backbone fabric
Figure 34

TI over FCR example

In the following procedure the three TI zones in the edge and backbone fabrics are all given the same
name, TI_Zone1. It is not required that the TI zones have the same name, but this is done to avoid
confusion. If several dedicated paths are set up across the FC router, the TI zones for each path can have
the same name.
1. In each edge fabric, set up an LSAN zone that includes Host 1, Target 1, and Target 2, so these devices
can communicate with each other. See
about creating LSAN zones.
2. Log in to the edge fabric 1 and set up the TI zone.
a. Issue the fabricShow command to display the switches in the fabric. From the output, you can
determine the front and translate domains.
E1switch:admin> fabricshow
Switch ID Worldwide Name
-------------------------------------------------------------------------
1: fffc01 50:00:51:e3:95:36:7e:04
4: fffc04 10:00:00:60:69:80:1d:bc
6: fffc06 50:00:51:e3:95:48:9f:a0
The Fabric has 3 switches
b. Issue the following commands to create and display a TI zone:
E1switch:admin> zone --create -t ti TI_Zone1 -p "4,8; 4,5, 1,-1; 6,-1"
E1switch:admin> zone --show
Defined TI zone configuration:
TI Zone Name: TI_Zone1
Port List: 4,8; 4,5; 1,-1; 6,-1
Status: Activated
Domain ID = 1
Domain ID = 2
9
1
7
4
Backbone
fabric
"Optimizing fabric
Enet IP Addr
0.0.0.0
10.32.72.4
0.0.0.0
Failover: Enabled
Target 1
Target 2
2
3
6
Edge fabric 2
Domain ID = 9
behavior" on page 291 for information
FC IP Addr
0.0.0.0
0.0.0.0 >"E1switch"
0.0.0.0
Fabric OS 6.1.x administrator guide 303
Name
"fcr_fd_1"
"fcr_xd_6_9"