Setting Up Ti Over Fcr (Sample Procedure); Ti Over Fcr Example - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

To display information about all TI zones in the defined configuration:
switch:admin> zone --show
Defined TI zone configuration:
TI Zone Name:
Port List:
Configured Status: Activated / Failover-Enabled
Enabled Status: Activated / Failover-Enabled
TI Zone Name:
Port List:
Configured Status: Activated / Failover-Enabled
Enabled Status: Deactivated / Failover-Enabled
TI Zone Name:
Port List:
Configured Status: Deactivated / Failover-Disabled
Enabled Status: Activated / Failover-Enabled

Setting up TI over FCR (sample procedure)

The following example shows how to set up TI zones over FCR to provide a dedicated path shown in
Figure 55. In this example, three TI zones are created: one in each of the edge fabrics and one in the
backbone fabric. The combination of these three TI zones creates a dedicated path for traffic between Host
1 in edge fabric 1 and Targets 1 and 2 in edge fabric 2.
Host 1 has port WWN 10:00:00:00:00:08:00:00
Target 1 has port WWN 10:00:00:00:00:02:00:00
Target 2 has port WWN 10:00:00:00:00:03:00:00
Host 1
8
Edge fabric 1
Domain ID = 4
= Dedicated path set up by TI zone in edge fabric 1
= Dedicated path set up by TI zone in edge fabric 2
= Dedicated path set up by TI zone in backbone fabric
Figure 55

TI over FCR example

356 Optimizing fabric behavior
greenzone:
2,2; 3,3; 5,3; 4,11;
purplezone:
1,2; 1,3; 3,3; 4,5;
bluezone:
9,2; 9,3; 8,3; 8,5;
Domain ID = 1
9
5
1
4
Backbone
fabric
Target 1
Domain ID = 2
2
3
6
7
Domain ID = 9
Target 2
Edge fabric 2