Displaying The Iscsi Virtual Target Lun Map; Displaying Iscsi Vt State And Status; Discovery Domain And Domain Set Configuration - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

3. Issue the iscsiCfg --commit all command to commit the changes to the database. If the LUN
deletion is one of several configuration changes, you may want to see
configuration" on page 274 for extra detail on the commit process.

Displaying the iSCSI virtual target LUN map

1. Connect and log in to the switch.
2. Issue the iscsiCfg --show lun command:
switch:admin> iscsicfg --show lun
Number of targets found: 2
Target: iqn.2006-10.com.example:disk001
Number of LUN Maps: 2
FC WWN
21:00:00:04:cf:e7:73:7e
2f:ff:00:06:2b:0d:12:99
Target: iqn.2002-10.com.brocade:21:00:00:04:cf:e7:74:cf
Number of LUN Maps: 1
FC WWN
21:00:00:04:cf:e7:74:cf

Displaying iSCSI VT state and status

The following information can be displayed for each iSCSI VT:
• Name—IQN for the iSCSI VT.
• State—Whether the FC target is online or offline.
• Status—Whether the iSCSI VT has been defined (configuration completed but not committed) or is
committed (active and available to iSCSI initiators).
• Authentication method—Indicates CHAP if authentication is enabled for the iSCSI VT.
1. Connect and log in to the switch.
2. Issue the iscsiCfg --show tgt command with the -v option to display the iSCSI VTs:
switch:admin> iscsicfg --show tgt -v
Number of records found: 2
Name: iqn.2006-10.com.example-disk001
State/Status: Online/Defined
Auth. Method: None
Name: iqn.2002-10.com.brocade:21:00:00:04:cf:e7:74:cf
State/Status: Online/Defined
Auth. Method: None

Discovery domain and domain set configuration

Discovery domains and discovery domain sets can be used to configure access control between iSCSI
initiators and iSCSI VTs manually.
A discovery domain (DD) controls iSCSI initiator access to iSCSI VTs. A DD is a group of iSCSI initiators
and iSCSI VTs identified by IQNs. The iSCSI initiators can access only the iSCSI VTs that are in the DD to
which they are assigned. When there are no discovery domains, all iSCSI initiators can access all iSCSI
VTs.
If iSNS (internet storage name service) is enabled, configure access control on the iSNS server; discovery
domains and discovery domain sets configured in Fabric OS are not supported if the iSNS service is
enabled on the fabric.
You can create four discovery domain sets (DDSets), but only one set can be enforced at a time. Discovery
domain sets allow you to enable and disable fabric-wide iSCSI VT access with a single command.
An enabled DDSet is enforced fabric-wide. In a deployment with an active DDSet, only iSCSI initiators in
an enforced DD can access iSCSI VT in the same DD.
Virtual LUN(s) Physical LUN(s)
0 0
1-2 0-1
Virtual LUN(s) Physical LUN(s)
0 0x0000000000000000
Fabric OS 6.1.x administrator guide 271
"Committing the iSCSI-related