xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Interface Name
IPv4 Address
IPv6 Address (EI Mode
Only)
Click the Apply button to accept the changes made.
Click the Clear button to clear all the information entered in the fields.
System Severity Settings
The Switch can be configured to allow alerts be logged or sent as a trap to an SNMP agent. The level at which the
alert triggers either a log entry or a trap message can be set as well. Use the System Severity Settings window to
set the criteria for alerts. The current settings are displayed below the System Severity Table.
To view the following window, click System Configuration > System Log Configuration > System Severity
Settings, as show below:
Figure 2–16 System Log & Trap Settings window (SI Mode Only)
Figure 2–17 System Log & Trap Settings window (EI Mode Only)
Description
Enter the IP interface name used.
Enter the IPv4 address used.
Enter the IPv6 address used.
Figure 2–18 System Severity Settings window
17