Configuration Work Flow
To configure the switches:
1 For each switch in the stack:
Connect it to a terminal, as described in the "Connecting the Switch
a
to the Terminal" on page 56.
Boot the switch, as described in the "Booting the Switch" on page 57.
b
Assign a unit ID to the switch, as described in "Assigning Unit IDs" on
c
page 48.
2 Connect the units in the stack to each other, as described in "Configuring
the Stack" on page 58.
3 Connect the Master unit to the terminal, reboot the unit and the Setup
Wizard is run automatically, as described in "Configuration Using the
Setup Wizard" on page 58.
4 Respond to the Setup Wizard prompts.
5 Continue managing the switch, either through the console or Telnet, using
the CLI or the web GUI.
Dell PowerConnect 55xx Systems User Guide
55