Dell PowerConnect 5524P User Manual page 546

Configuring MED on Ports Using CLI Commands
The following commands are used to set the fields in the MED Port Settings
pages.
Table 17-4. LLDP Properties CLI Commands
CLI Command
lldp med enable [tlv ... tlv4]
no lldp med enable
lldp med network-policy
{add|remove} number
no lldp med network-policy
number
lldp med location
{{coordinate data}|{civic-
address data}|{ecs-elin
data}}
no lldp med location
{coordinate|civic-
address|ecs-elin}
show lldp med configuration
[gigabitethernet|tengigabitet
hernet] port-number
show lldp local
[gigabitethernet|tengigabitet
hernet] port-number
546
Dell PowerConnect 55xx Systems User Guide
Description
Enables LLDP MED on an interface.
Use the no form of this command to
disable LLDP MED on an interface.
Attaches or removes an LLDP MED
network policy on an interface.
Use the no form of this command to
remove all the LLDP MED network
policies from the interface
configure the LLDP MED for an
interface.
Use the no form of this command to
delete location information for an
interface.
Displays the LLDP MED configuration
for all interfaces or for a specific
interface.
Displays the LLDP information that is
advertised from a specific port.