Eaton Powerware 9130 User Manual page 92

SPECIFICATIONS
Table 19. Electrical Output (All Models)
All Models
Voltage Regulation
Efficiency
Frequency Regulation
Nominal Outputs
Frequency
Output Overload (Normal Mode)
Output Overload (Bypass Mode)
Output Overload (Battery Mode)
Voltage Waveform
Harmonic Distortion
Transfer Time
Power Factor
Load Crest Factor
84
Eaton ® 9130 UPS (700–3000 VA) User's Guide
Normal Mode
±2%
>95% (High Efficiency mode), >88%
Sync with line ±3 Hz of nominal line
frequency (outside this range:
±0.1 Hz of auto-selected nominal
frequency)
Low Voltage Models
100/110/120/127V
(voltage configurable or
auto-sensing)
1000/1500/2000/3000 VA
0.9/1.35/1.8/2.7 kW
50 or 60 Hz, autosensing or configurable as a frequency converter
100–102%: Activates Overload alarm. (Level 1)
102–129%: Load transfers to Bypass mode after 12 seconds. (Level 2)
130–149%: Load transfers to Bypass mode after 2 seconds. (Level 3)
>150%: Load transfers to Bypass mode after 100 ms. (Level 4)
NOTE Default configuration transfers immediately to Bypass at >102%.
100–109%: Activates Overload alarm. (Level 1)
110–129%: UPS shuts down after 5 minutes. (Level 2)
130–149%: UPS shuts down after 15 seconds. (Level 3)
>150%: UPS shuts down after 300 ms. (Level 4)
100–102%: Activates Overload alarm. (Level 1)
102–129%: UPS shuts down after 12 seconds. (Level 2)
130–149%: UPS shuts down after 2 seconds. (Level 3)
>150%: UPS shuts down after 100 ms. (Level 4)
<3% THD on linear load; <5% THD on non-linear load
Online mode: 0 ms (no break)
High Efficiency mode: 5 ms maximum (due to loss of utility)
S
164201718 Rev 2 www.powerware.com
Battery Mode
Nominal output voltage ±3%
>79.5% (700 VA),
>82% (1000–1500 VA),
>84% (2000–3000 VA)
±0.1 Hz of auto-selected nominal
frequency
High Voltage Models
200/208/220/230/240V
(voltage configurable or
auto-sensing)
1000/1500/2000/3000 VA
0.9/1.35/1.8/2.7 kW
Sine wave
0.9
3 to 1