Eaton Powerware 9130 User Manual page 43

10. Verify that the
UPS is operating normally and any loads are powered.
The UPS should be in Normal mode.
ESC
11. Press the
12. If optional EBMs are installed, see "Configuring the UPS for EBMs"
on page 51 to set the number of installed EBMs.
13. To change any other factory-set defaults, see "Operation" on
page 37.
NOTE Eaton recommends setting the date and time.
NOTE At initial startup, the UPS sets system frequency according to input line frequency
(input frequency auto-sensing is enabled by default). After initial startup, auto-sensing is
disabled until manually re-enabled by output frequency setting.
NOTE At initial startup, input voltage auto-sensing is disabled by default. When manually
enabled by output voltage setting, at the next AC startup the UPS sets output voltage
according to input line voltage. After the subsequent startup, auto-sensing is disabled until
manually re-enabled by output voltage setting.
14. If you installed an optional REPO, test the REPO function:
Activate the external REPO switch. Verify the status change on the
UPS display.
Deactivate the external REPO switch and restart the UPS.
NOTE The internal batteries charge to 90% capacity in less than 3 hours. However, Eaton
recommends that the batteries charge for 48 hours after installation or long-term storage. If
optional EBMs are installed, see the recharge times listed in Table 25 on page 90.
15. Keep your UPS firmware updated. See "Updating the UPS
Firmware" on page 73.
Eaton ® 9130 UPS (700–3000 VA) User's Guide
indicator illuminates solid, indicating that the
button until the start screen appears.
S
164201718 Rev 2 www.powerware.com
INSTALLATION
35