Eaton Powerware 9130 User Manual page 39

A small amount of arcing may occur when connecting the internal batteries. This is normal
and will not harm personnel. Connect the cables quickly and firmly.
2. Connect the internal battery connector (see Figure 15).
Connect the white connectors together, connecting red to red, and
black to black. Press the two parts tightly together to ensure a
proper connection.
3. Remove the two screws from the screw mounts and retain (see
Figure 15).
4. Place the battery connector between the screw mounts. Reinstall
the two screws to hold the connector in place.
5. Replace the UPS front cover.
To replace the cover, verify that the ribbon cable is protected, then
insert the clips on the back of the cover into the cabinet and push
firmly to snap the cover into place.
Eaton ® 9130 UPS (700–3000 VA) User's Guide
C A U T I O N
Figure 15. Connecting the UPS Internal Batteries
S
164201718 Rev 2 www.powerware.com
INSTALLATION
31