Chapter 1:
Setting Up
the Printer
WARNING: Six people are
required to unpack and set
up the printer.
Note: When choosing a
place for the printer, leave
adequate room for easy
access and ventilation.
Avoid locations subject to
direct sunlight, excessive
heat, humidity, or dust.
Also avoid locations near
potential sources of
electromagnetic
interference, such as
loudspeakers, cordless
phones, TVs, or air
conditioners.
This chapter includes the following information:
Unpacking and assembling the Pro GS6000
•
Installing the Auto Take-Up Reel
•
Removing the printer packing materials
•
Connecting the power cord
•
Installing ink
•
Connecting to your computer and network
•
Updating the printer firmware
•
Configuring the printer for a network
•
Unpacking and Assembling the Pro GS6000
Before beginning assembly, make sure you have sufficient space to set up and
use the printer. The following illustration shows the minimum space
required for using the Pro GS6000:
23.6 in.
(60 cm)
You need an even larger floor space to assemble the printer and stand, so be
sure to prepare a large, clear area before unpacking them. Also make sure you
save the box and packaging in case you need to ship the printer later.
17
39.4 in.
(100 cm)
17
61 in.
(155 cm)
39.4 in.
(100 cm)