Cleaning The Cleaning Wiper, Capping Assemblies, And Print Head Casings - Epson Stylus Pro GS6000 Setup and Setup And Use Manual

Caution: You must
complete the process of
cleaning the cleaning
wiper, capping
assemblies, and print
head casing within 15
minutes to prevent the
print head from drying
out.
Note: If you need more
swabs, purchase an
Additional Printer
Maintenance Kit (1 year
supply). See page 10 for
ordering information.
2. When all the waste ink has drained, close the valve on the spigot.
3. Wipe the mouth of the spigot on the waste ink tank with a cloth.
4. Dispose of the waste ink and the cloth in compliance with industrial
waste disposal laws and local government ordinances as required in your
area. See the warning on page 78 for details.
Cleaning the Cleaning Wiper, Capping
Assemblies, and Print Head Casings
Depending on your print volume, you should to clean the print head
cleaning wiper, capping assemblies, and print head casings once a month.
You may also need to clean them if you notice blurred ink or gaps in your
printouts after cleaning the print head.
You will need the plastic gloves and a cleaning swabs that came in the
Maintenance Kit and the metal tray included with your printer to clean the
cleaning wiper, capping assemblies, and print head casings.
Plastic gloves
Place your used gloves and swabs in the metal tray when you are finished to
avoid getting ink on any of the printer parts; this may damage the plastic.
Maintaining the Printer
Cleaning swabs
79
|
Metal tray
79