Epson Stylus Pro GS6000 Setup and Setup And Use Manual page 101

Message
CARRIAGE LOCKED
RELEASE THE CARRIAGE
LOCK
COMMAND ERROR
CHECK DRIVER
SETTINGS
DRAIN TANK FULL
DRAIN WASTE INK FROM
THE DRAIN TANK
FRONT COVER OPEN
CLOSE FRONT COVER
F/W INSTALL ERROR
UPDATE FAILED
RESTART THE PRINTER
INK CARTRIDGE
NON-GENUINE
CARTRIDGE MAY NOT
PERFORM AT OPTIMUM.
CONTINUE?
<YES NO>
INK CARTRIDGE
PLEASE USE GENUINE
EPSON INK CARTRIDGES
INK CARTRIDGE
REPLACE INK
CARTRIDGE
INK CARTRIDGE
DO YOU ACCEPT THIS?
<ACCEPT DECLINE>
The following table lists the messages in alphabetical order and includes an
explanation and instructions for correcting the problem.
Explanation
The print head is locked.
You may be using the wrong
printer driver.
Damaged data was sent to the
printer or the data has an
incorrect command.
The waste ink tank is full.
Front cover is open.
Firmware update failed.
A non-genuine ink cartridge is
installed.
A non-genuine ink cartridge is
installed.
Ink cartridge(s) are expended
(printing stops).
A non-Epson ink cartridge is
installed.
Response
Remove the bracket securing the print head;
see page 27.
Press and hold the
three seconds to cancel the print job. Make
sure you installed the correct driver for your
printer.
Dispose of the waste ink in the waste ink tank.
See page 78 for instructions.
Close the front cover.
Restart the printer, then update the firmware
again; see page 38 for instructions.
Press the r button to select NO and replace
the ink cartridge with a genuine Epson ink
cartridge; see page 75. Otherwise, press l to
select YES.
Replace the ink cartridge with a genuine Epson
ink cartridge; see page 75.
Replace the ink cartridge(s) indicated on the
LCD display; see page 75.
Press the r button to select DECLINE and
replace the ink cartridge with a genuine Epson
ink cartridge; see page 75. Pressing l to select
ACCEPT may cause damage not covered by
your warranty.
101
Solving Problems
Pause button for
| 101