Configuring The Printer For Your Network - Epson Stylus Pro GS6000 Setup and Setup And Use Manual

Caution: Don't turn off
the printer while the
firmware is updating.
5. Make sure your printer is turned on, its LCD displays
connected to your computer or network, then choose your printer.
6. Click and find the firmware file that you just downloaded and
Browse
extracted. Select the file and click
7. If the firmware version of the file is newer, click
firmware updating process. (If it is the same, you don't need to update.)
8. When the update is complete, close the Firmware Updater window and
Epson LFP Remote window.
If you connected your printer to a network, follow the instructions in the
next section to configure the printer for your network.

Configuring the Printer for Your Network

Once the printer is connected to your network, follow these steps to
configure it:
1. Turn on the printer.
2. Start EpsonNet Config.
The EpsonNet Config program searches for all Epson printers on the
network and displays the MAC address for each printer that it finds.
Setting Up the Printer
Choose
39
, and it is
READY
.
to start the
Update
| 39