Moving The Printer On The Stand - Epson Stylus Pro GS6000 Setup and Setup And Use Manual

92 | Cleaning, Storing, and Transporting the Printer
Caution: Do not remove
the ink cartridges or leave
the print head uncapped
when moving the printer;
otherwise the print head
may dry out and be
unable to print properly.
Never turn off the printer
by disconnecting the
power cord or turning off
power to the electrical
outlet.
Do not tilt the printer,
stand it on end, or turn it
upside down when
moving it, or ink will leak
and you may damage the
printer.
Caution: Do not roll the
printer on angled or
uneven surfaces.

Moving the Printer on the Stand

When you need to move the printer a short distance, such as within the same
building, you can roll the printer on its casters.
1. Open the right maintenance cover and make sure the print head is on
the right side (in the capped position).
If it is not capped, turn on the printer, wait a moment, then turn it off
and check again. Never move the print head by hand.
2. Dispose of any waste ink in the waste ink tank (see page 78).
3. Press the P Power button to turn off the printer.
4. Disconnect the power cord and interface cable.
5. Make sure the front cover is closed.
6. Rotate the feet counter-clockwise to raise them.
7. Carefully roll the printer to its new location, then rotate the feet
clockwise to stabilize the stand.
92