Replacing Roll Media - Epson Stylus Pro GS6000 Setup and Setup And Use Manual

66 | Handling Media and Printouts
Caution: Do not release
the paper lever while the
P Power light is flashing,
or you may damage the
printer.

Replacing Roll Media

When you run out of media or need to change the type of media you are
using, follow these steps:
1. Make sure the P Power light is not flashing, then release the paper lever.
LEVER RELEASED
2. Turn the roll backward using the roll paper holders and remove any
remaining media from the feed slot.
3. Release the right roll paper lever and slide the holder off the end of the
roll.
appears on the LCD display.
66