Using The Printer - Epson Stylus Pro GS6000 Setup and Setup And Use Manual

Caution: Always turn
the printer off using the
P Power button. When
you press this button,
POWER OFF appears on
the LCD panel and the
P Power light flashes.
Do not unplug the printer
or turn off the power to
the printer until the panel
shuts off and the
P Power light stops
flashing. This ensures
that the print head is
safely capped.
The printer's power cord is designed for use with the printer only. Using
•
it with other equipment may result in fire or electric shock.
Do not use a damaged or frayed power cord.
•
If you use an extension cord with the printer, make sure the total ampere
•
rating of devices plugged into the extension cord does not exceed the
cord's ampere rating. Also, make sure the total ampere rating of all
devices plugged into the wall outlet does not exceed the wall outlet's
ampere rating.

Using the Printer

Do not block or cover the openings in the printer's case.
•
Do not put your hand inside the printer or touch the ink cartridges
•
during printing.
Do not move the print head by hand unless instructed to do so by an
•
Epson service technician; otherwise you may damage the printer.
Do not touch the post heater during printing. It is hot and may cause a
•
burn.
Do not touch the paper feed slot, platen, or post heater while the heaters
•
are operating. They are hot and may cause a burn.
Do not touch the steel belt inside the printer; otherwise, you may be
•
injured.
Do not insert objects through the slots. Take care not to spill liquid on
•
the printer.
Do not use aerosol products that contain flammable gases inside or
•
around the printer. Doing so may cause fire.
13
Introduction | 13