Loading Media (Sc-S30600 Series) - Epson SureColor SC-S70600 User Manual

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
c
Important:
❏ Do not use the media holding plates with
media that is more than 0.4 mm thick.
The media holding plates could touch
and damage the print head.
❏ Move the media holding plates to the left
and right edges of the platen when they
are not in use.
❏ Do not use the media holding plates if the
sides of the printed media are smudged or
torn.
❏ Leave left and right margins of over 10
mm when using the media holding
plates. Narrower margins could result in
printer printing over the plates (this does
not apply when ink layering is used).
T
Close the front cover.
Loading Media (SC-S30600
series)
The procedure for loading media varies depending on
whether you are using the installed media feeding unit
or the optional heavy roll media system.
Follow the steps below when using the supplied media
feeding unit.
When the Heavy Roll Media Feeding Unit is installed,
see: U "Using the Optional Heavy Roll Media Feeding
Unit" on page 48
When the Standard Media Feeding
Unit Is Installed
This section describes how to load media when the
standard media feeding unit is installed.
Basic Operations
!
Caution:
Because the media is heavy, it should not be carried
by one person. When loading or removing the
media, use at least two persons.
A
Turn on the printer by pressing the P button.
B
Loosen the roll holder fixing screws and adjust
the roll holders so that the gap between the two is
wider than the media.
Center the roll supports between the roll holders.
c
Important:
If the right holder handle shaft is not visible,
rotate the holder forward until it stops. The
media can not be properly loaded if the handle
shaft is not visible.
C
Place media on the roll support oriented
according to how it is rolled (see below) and
position it as indicated by the mark on the label.
Printable Side Out
43