Performing Feed Adjustment During Printing - Epson SureColor SC-S70600 User Manual

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
K
Pattern length is displayed in the control panel./
Using the d/u buttons, enter the value recorded
in Step 10 and press the Z button.
Secondary Adjustment
L
Perform Steps 1 to 6.
M
Use the d/u buttons to select Secondary and
press the Z button twice.
N
The printer will print a test pattern.
When printing is complete, the media will
automatically be fed to a position where the
pattern is clearly visible.
Cut the media if necessary.
"Cutting Media" on page 54
U
Note:
To rewind the media, press u.
O
Check the pattern and note the pattern number
with the lightest colors.
In the following example, this would be pattern
number 3.
1 2
A
P
The pattern number is displayed in the control
panel./Using the d/u buttons, enter the pattern
number recorded in Step 14 and press the Z
button.
Q
Enter the number for each line, from A to F, and
press the Z button.
R
The menus will close after you enter the pattern
number for the last line.
Basic Operations
3 4 5
69
Performing Feed Adjustment
During Printing
Buttons that are used in the following settings
A
Press the button during printing.
B
An adjustment value will be displayed.//Use the
d/u buttons to select a value.
If the feed amount is too small, black bands (dark
stripes) will appear; adjust the feed amount
upwards.
If, in contrast, the feed amount is too large, white
bands (pale stripes) will appear; adjust the feed
amount downwards.
C
If you are not satisfied with the results, use the
d/u buttons to enter an adjustment value.
D
Press the Z button when settings are complete.
Once the feed amount has been adjusted,
printing will continue at the new value.
Note:
The new value is erased when:
❏ The media loading lever is raised
❏ The printer is turned off
❏ Changes are made to Feed Adjustment in the
Media Setup menu.