Show Errdisable Detect - Cisco 3020 - Catalyst Blade Switch Command Reference Manual

show errdisable detect

show errdisable detect
Use the show errdisable detect user EXEC command to display error-disabled detection status.
Syntax Description | begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(25)SEF
Usage Guidelines A displayed
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples
This is an example of output from the show errdisable detect command:
Switch> show errdisable detect
ErrDisable Reason
-----------------
udld
bpduguard
security-violatio
channel-misconfig
psecure-violation
vmps
loopback
pagp-flap
dtp-flap
link-flap
gbic-invalid
dhcp-rate-limit
unicast-flood
storm-control
ilpower
Note Though visible in the output, the ilpower, storm-control, and unicast-flood fields are not valid.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
2-302
show errdisable detect [ | {begin | exclude | include} expression]
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
error reason refers to an invalid small form-factor pluggable (SFP) module.
gbic-invalid
Detection status
----------------
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
OL-8916-01