Chapter 1 Using The Command-Line Interface; Cli Command Modes - Cisco 3020 - Catalyst Blade Switch Command Reference Manual

Using the Command-Line Interface
The switch is supported by Cisco IOS software. This chapter describes how to use the switch
command-line interface (CLI) to configure software features.
•
•
•
•
•
•
In this document, IP refers to IP version 4 (IPv4).

CLI Command Modes

This section describes the CLI command mode structure. Command modes support specific Cisco IOS
commands. For example, the interface interface-id command only works when entered in global
configuration mode.
These are the main command modes for the switch:
•
•
•
•
•
•
•
OL-8916-01
For a complete description of the commands that support these features, see
Catalyst Blade Switch 3020 for HP Cisco IOS Commands."
For information on the boot loader commands, see
HP Boot Loader Commands."
For information on the debug commands, see
HP Debug Commands."
For information on the show platform commands, see
3020 for HP Show Platform Commands."
For more information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command
Summary.
For task-oriented configuration steps, see the software configuration guide for this release.
User EXEC
Privileged EXEC
Global configuration
Interface configuration
Config-vlan
VLAN configuration
Line configuration
C H A P T E R
Appendix A, "Cisco Catalyst Switch 3020 for
Appendix B, "Cisco Catalyst Blade Switch 3020 for
Appendix C, "Cisco Catalyst Blade Switch
Cisco Catalyst Blade Switch 3020 for HP Command Reference
1
Chapter 2, "Cisco
1-1