Cisco 3020 - Catalyst Blade Switch Command Reference Manual page 586

vtp (global configuration)
•
•
You cannot save password, pruning, and version configurations in the switch configuration file.
Examples This example shows how to rename the filename for VTP configuration storage to vtpfilename:
Switch(config)# vtp file vtpfilename
This example shows how to clear the device storage filename:
Switch(config)# no vtp file vtpconfig
Clearing device storage filename.
This example shows how to specify the name of the interface providing the VTP updater ID for this
device:
Switch(config)# vtp interface gigabitethernet
This example shows how to set the administrative domain for the switch:
Switch(config)# vtp domain OurDomainName
This example shows how to place the switch in VTP transparent mode:
Switch(config)# vtp mode transparent
This example shows how to configure the VTP domain password:
Switch(config)# vtp password ThisIsOurDomain'sPassword
This example shows how to enable pruning in the VLAN database:
Switch(config)# vtp pruning
Pruning switched ON
This example shows how to enable Version 2 mode in the VLAN database:
Switch(config)# vtp version 2
You can verify your settings by entering the show vtp status privileged EXEC command.
Related Commands Command
show vtp
vtp (VLAN
configuration)
Cisco Catalyst Blade Switch for HP Command Reference
2-558
If you are configuring a Token Ring bridge relay function (TrBRF) or Token Ring concentrator relay
function (TrCRF) VLAN media type, you must use Version 2.
If you are configuring a Token Ring or Token Ring-NET VLAN media type, you must use Version 1.
Description
status Displays the VTP statistics for the switch and general information about the
VTP management domain status.
Configures VTP domain-name, password, pruning, version, and mode.
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
OL-8916-01