Fiber Optic Fibre Channel Cables - HP 6100 User Manual

Table 2 Operational I/O module status indicators
Upper
Off
On Flashing, then On
On
Flashing
Table 3 Non-operational I/O module status indicators
Upper
On
Off
Flashing
On
Off

Fiber Optic Fibre Channel cables

The Enterprise Virtual Array uses orange, 50-µm, multi-mode, fiber optic cables for connection to
the SAN. The fiber optic cable assembly consists of two 2-m fiber optic strands and small form-factor
connectors on each end. See
28 Enterprise Virtual Array hardware components
Power Lower
On Off
On
On On
Flashing Flashing
Power Lower
On Off
NOTE:
On On
On On
On Flashing
NOTE:
in response to a locate command. You can flash each of the lights independently
during a locate action.
Off Off
Figure 9 (page
I/O Module is operational.
Top port—Fibre Channel drive enclosure signal detected.
Power—Flashes for about 90 seconds after initial power application,
then remains constant.
Bottom port—Fibre Channel drive enclosure signal detected.
Top port—Fibre Channel drive enclosure signal detected.
Power—Present.
Bottom port—Fibre Channel drive enclosure signal detected.
When the locate function is active, all three indicators flash
simultaneously. The Locate function overrides all other indicator
functions. Therefore, an error could be detected while the Locate
function is active and not be indicated until the Locate action terminates.
Top port—Fibre Channel drive enclosure signal detected.
Power—Present.
Bottom port—No Fibre Channel drive enclosure signal detected. Check
transceiver and fiber cable connections.
This status applies to configurations with and without FC loop switches.
Top port—No Fibre Channel drive enclosure signal detected. Check transceiver
and fiber cable connections.
Power—Present.
Bottom port—Fibre Channel drive enclosure signal detected .
Top port—EMU detected possible transceiver problem. Check transceiver and
fiber cable connections.
Power—Present.
Bottom port—Fibre Channel drive enclosure signal detected .
Top port—Fibre Channel drive enclosure signal detected.
Power—Present.
Bottom port—EMU detected possible transceiver problem. Check transceiver
and fiber cable connections.
The EMU will not flash the lower indicator on its own. It will flash only
No I/O module power.
I/O module is nonoperational.
Check power supplies. If power supplies are operational, replace I/O module.
29).
Descriptions
Descriptions