D Non-Standard Rack Specifications; Rack Specifications; Internal Component Envelope; Eia310-D Standards - HP 6100 User Manual

D Non-standard rack specifications

The appendix provides information on the requirements when installing the EVA4x00/6x00/8x00
in a non-standard rack. All the requirements must be met to ensure proper operation of the storage
system.

Rack specifications

Internal component envelope

EVA component mounting brackets require space to be mounted behind the vertical mounting rails.
Room for the mounting of the brackets includes the width of the mounting rails and needed room
for any mounting hardware, such as screws, clip nuts, etc.
dimensions required for the mounting space for the EVA product line. It does not show required
space for additional HP components such as servers.
Figure 47 Mounting space dimensions

EIA310-D standards

The rack must meet the Electronic Industries Association, (EIA), Standard 310-D, Cabinets, Racks
and Associated Equipment. The standard defines rack mount spacing and component dimensions
specified in U units.
Copies of the standard are available for purchase at http://www.eia.org/.

EVA cabinet measures and tolerances

EVA component rack mount brackets are designed to fit cabinets with mounting rails set at depths
from 27.5 inches to 29.6 inches, inside rails to inside rails.

Weights, dimensions and component CG measurements

Cabinet CG dimensions are reported as measured from the inside bottom of the cabinet (Z), the
leading edge of the vertical mounting rails (Y), and the centerline of the cabinet mounting space
(X). Component CG measurements are measured from the bottom of the U space the component
Figure 47 (page 143)
Rack specifications 143
shows the