Ricoh Aficio SP C232DN Operating Instructions Manual page 168

Preparing for Printing
Note
❒ When you click [Finish], the [Digital Signature Not Found] dialog box might
appear. To continue the installation, click [Yes].
❒ Auto Run might not work under certain operating system settings. If this
1
is the case, launch "Setup.exe" from the CD-ROM root directory.
❒ To stop the selected software installing, click [Cancel] before the installa-
tion is complete.
❒ A message appears if there is a newer version of the printer driver already
installed. If there is, you cannot install the printer driver using Auto Run.
If you still want to install the printer driver, use [Add Printer]. See p.14 "If a
Message Appears during Installation".
Reference
For details about reconfiguring the printer settings, when the search for
network printer fails, see p.4 "If the network printer search fails".
For details about the network connection, see Hardware Guide.
If the network printer search fails
This section explains how to reconfigure the settings if the network printer
search fails during the installation.
Use the control panel to check the printer's IP address settings, and then recon-
figure these settings if necessary.
❖ Reconfigure the printer's IP address
Use the control panel to obtain the printer's current IP address settings by
checking the [IP Address], [Subnet Mask], and [Gateway Address] settings. You
can change these settings if necessary. For details, see p.58 "Changing the
Host Interface Menu".
❖ Reconfigure the port settings
A
On the [Start] menu, open the [Printers] window.
B Click the icon of this printer. On the [File] menu, click [Properties].
The printer properties appears.
C Click the [Ports] tab, and then click [Add Port].
D Click [Standard TCP/IP Port], and then click [New Port...].
The Add Standard TCP/IP Printer Port Wizard appears.
E
Click [Next >].
F Enter the printer's IP address that is printed on the test page, and then click
[Next >].
G Click [Finish].
4