Ricoh Aficio SP C232DN Operating Instructions Manual page 123

Troubleshooting
Prints do not stack properly.
Multiple pages are fed at once.
8
Paper gets wrinkles.
102
Status
• Paper is damp. Use paper that has been stored properly.
• Pull out the extender.
• Perform the following operation.
• Raise the appropriate stop fence (forward fence for A4,
• There may be a gap between the front end paper guide
• Paper is either too thick or too thin.
• Paper has already been printed on.
• Number of paper set in the tray exceeds the limit. Con-
• Paper is static. Use paper that has been stored properly.
• The friction pad or paper feed roller or registration roller
• Check that paper has not been added while there is still
• Fan the paper before loading.
• Paper is damp. Use paper that has been stored properly.
• Paper is too thin.
• There may be a gap between the front end paper guide
Possible Causes, Descriptions, and Solutions
See p.37 "Paper and Other Media".
Press the {Menu} key on the control panel, select [Sys-
tem], and then press the {#Enter} key.
Press the {T} or {U} key and select [Anti-Humidity], and
then press the {#Enter} key.
Press the {T} or {U} key and select [Mode 2] or [Mode
3], and then press the {#Enter} key.
Note that the first print takes longer than subsequent
prints to complete.
See the printer driver help.
rear fence for legal size prints).
See, p.1 "Exterior: Front View".
and paper, or between the paper guide both side and pa-
per in the paper tray. Make sure there are no gaps.
See p.47 "Loading Paper".
See p.37 "Paper and Other Media".
See p.37 "Paper and Other Media".
firm that the top of the stack is not higher than the limit
mark inside the tray.
See p.37 "Paper and Other Media".
See p.37 "Paper and Other Media".
may be dirty. Clean the pertinent section as necessary.
See p.86 "Cleaning the Friction Pad and the Paper Feed
Roller"
some left in the tray.
Only add paper when there is none left in the tray.
See p.37 "Paper and Other Media".
See p.37 "Paper and Other Media".
and the paper, or between the paper guide both side and
the paper in the paper tray. Make sure there are no gaps.
See p.47 "Loading Paper".