Replacing The Side Cover - IBM 6219 - IntelliStation M - Pro User Manual

v A 19 mm (0.75 in.) rope clip or wire rope (similar to National Manufacturing No.
v Threaded nuts that fit the rope clip
v A security cable
v A lock, such as a combination lock or padlock
Complete the following steps to install a rope clip:
1. Turn off the computer and all attached devices.
2. Disconnect all external cables and power cords; then, remove the side cover.
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
5. Thread the cable through the rope clip and around an object that is not part of
6. If you have other options to install or remove, do so now; otherwise, replace the
7. Reconnect the external cables and power cords. Turn on the attached devices,

Replacing the side cover

If you removed the support bracket, reinstall it before you replace the side cover.
See "Removing and installing the support bracket" on page 35.
Note: The rear adapter retaining bracket rests against the computer side cover.
Complete the following steps to replace the side cover:
1. Before installing the cover, check that all cables, adapters, and other
3230, Stock No. 176-735)
See "Removing the side cover" on page 34.
or permanently secured to the building structure or foundation, and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, be certain it does not interfere with other cables
connected to the computer.
Rope clip
side cover (see "Replacing the side cover").
and turn on the computer.
You might find it easier to lay the computer on its side to replace the side
cover.
components are installed and seated correctly and that you have not left loose
tools or parts inside the computer.
Chapter 4. Installing options
47