Removing And Installing The Support Bracket - IBM 6219 - IntelliStation M - Pro User Manual

Complete the following steps to remove the side cover of the computer:
1. Review the safety information beginning on page vii.
2. Turn off the computer and all attached devices (see "Turning off the computer"
on page 19).
3. Disconnect all external cables and power cords.
4. Pull the cover-release latch away from the computer, and push the cover toward
the rear of the computer. Lift the side cover off the computer and set it aside.
94
13
For instructions for replacing the side cover, see "Replacing the side cover" on
page 47.
Attention: For proper cooling and airflow, replace the cover before turning on the
computer. Operating the computer with the cover removed might damage computer
components.

Removing and installing the support bracket

When working with some devices, such as hard disk drives, adapters, and memory
modules, you must first remove the support bracket to access the device.
Complete the following steps to remove the support bracket:
1. Review the "Installation guidelines" on page 29.
2. Remove the side cover ("Removing the side cover" on page 34).
3. Pull out on the rear end of the support bracket approximately 150 mm (6 in.).
35
Chapter 4. Installing options