Connecting External Options - IBM 6219 - IntelliStation M - Pro User Manual

2. Install the side cover by placing it into position on the computer. Be certain the
3. If you have not done so already, make sure that the two front stabilizing feet are
4. Reconnect the external cables and power cords to the computer; then, connect
5. Turn on the attached devices; then, turn on the computer.

Connecting external options

You can connect a number of optional external devices to the connectors on the
rear and front of the computer.
Complete the following steps to attach an external device:
1. Review the "Installation guidelines" on page 29, the safety precautions listed in
2. Be sure that your computer and all attached devices are turned off.
3. Follow the instructions that come with the option to prepare it for installation and
Note: If you are attaching a SCSI device, see "Ultra320 SCSI connector" on
48
IBM IntelliStation M Pro Type 6219: User's Guide
tabs on the underside of the cover match up to the holes along the sides of the
computer. Press down on the cover-release latch as you slide the side cover
forward to lock the side cover.
rotated outward so that they properly support the computer. Rotate each foot
outward 90 degrees (see "Moving the stabilizing feet" on page 34).
the power cords to electrical outlets.
Statement 1 and Statement 5 in the safety information on page vii, and the
documentation that comes with your options.
to connect it to the computer.
page 52 for SCSI ID and cabling information.
94
13