Password Setting - IBM Aptiva 2156 Hardware Maintenance Service

Power Button Override < 4 sec
When set to Suspend, this parameter adds the suspend function to the
system power button on the front panel. The suspend function allows you to
put the system into suspend mode by pressing the power button for less than
four seconds while the system is on. When this parameter is set to Instant Off,
the power button simply turns the system power on or off. This parameter is
set to Instant Off by default.
Ring Power-up Control
This parameter allows you to enable or disable the Modem Wake-Up on Ring
feature. When enabled and if the computer is in suspend, an incoming call
automatically resumes normal power on mode. When disabled, the system
does not return to the "normal on" state even if there is an incoming modem
access. The default setting is Enabled.
Lan Power Up Control
This parameter allows you to enable or disable the Wake Up On Lan
function.When enabled and if the computer is susspend, an imcoming data
packet from any other network neighbor will wake up ths system unit.
.

Password Setting

Select this parameter and press the left- or right-arrow key to display the
Password window. In this window, you can either set up a password or both to
restrict the use of your computer. You can also change or remove the
password.
If you set up a password, you must type this password each time you turn on
your computer. If you do not key in the correct password, you cannot use your
computer. You must also type this password if you want to enter Setup.
1-17