Disaster Recovery Character Ui - HP BB118BV - StorageWorks Data Protector Express Package User's Manual & Technical Reference

• Linux, and
• NetWare.
To perform Disaster Recovery for one of the operating system listed above, do the following:
1.
Remove all media from all cartridge disk drives, tape drives and/or library magazine slots.
2.
Insert the first bootable media:
a. If you are using a single tape or removable disk drive, insert the first bootable media into
the drive.
b. If you are using a library, insert the first (or only) bootable media into slot 1 of the magazine. If
the full backup used two or more media, insert the rest of the full backup media into the library
magazine in their proper order. See
3.
Perform any special steps for booting your computer from the bootable device (refer to your device
and system documentation). Most bootable drives use a combination of power cycling and pressing
the Eject button on the front panel. Many also require that you update the computer BIOS.
NOTE:
For disaster recovery, use only full backup media that were created with the Overwrite all media
option. After disaster recovery is complete and your system has restarted, use the standard Data
Protector Express options to restore any incremental or differential media to your system. The
standard Data Protector Express restore procedure optimizes restoration and restores incremental
and differential media faster than the disaster recovery process.
4. When the Disaster Recovery (Phase 2) screen appears, select one of the following options:
a. Recover Boot Disk. Select this option to only recover the boot disk. Use it if your boot disk
is corrupt or if you replaced the boot disk.
226 Disaster Recovery
Disaster Recovery with Libraries
Figure 137 Disaster recovery character UI
below.