Transmission Assembly - DAELIM ROADWIN VJ125 Service Manual

TRANSMISSION ASSEMBLY

MAIN SHAFT
M-3 GEAR
COUNTER SHAFT
C-1 GEAR
COUNTER TRANSMISSION SHAFT
C-3 GEAR
C-4 GEAR
M-4 GEAR
M-5 GEAR
MAIN SHAFT
MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING
MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING
MAIN SHAFT BEARING MAIN SHAFT BEARING
MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING MAIN SHAFT BEARING
REMOVER 15mm REMOVER 15mm REMOVER 15mm REMOVER 15mm REMOVER 15mm
REMOVER 15mm REMOVER 15mm REMOVER 15mm REMOVER 15mm REMOVER 15mm REMOVER 15mm
REMOVER 15mm REMOVER 15mm REMOVER 15mm REMOVER 15mm
REMOVER 15mm REMOVER 15mm REMOVER 15mm
CRANKCASE/TRANSMISSION/CRANKSHAFT
C-5 GEAR
M-2 GEAR
Coat the gear and gear bush with clean engine oil
and install the main shaft and counter shaft.
Check the gears for freedom of movement or
rotation on the shaft.
Note the installation direction of each snap ring.
Do not use the worn snap ring again.
Check the snap rings are seated in the grooves
spinning the rings. Align the end gaps of the snap
ring with the grooves of spline.
Install the main shaft and counter shaft into the left
crankcase together.
C-2 GEAR
DRIVE SPROCKET
11-9