Sending A Fax Manually; Sending A Fax Manually After Using The Telephone - Konica Minolta bizhub C25 Facsimile Manual

Sending a Fax Manually

Sending a Fax Manually After Using the Telephone

If the machine is connected to a telephone and the same line is used for both
phoning and faxing, the document can simply be sent after talking with the
recipient over the phone.
This is useful, for example, if you want to tell the recipient that you are send-
ing a fax.
1
Load the document into the ADF.
d
d
2
If desired, select the image quality.
d
3
Pick up the handset and check that the dial tone can be heard.
4
Specify the fax number of the recipient by using the telephone to dial the
fax number.
d
d
5
After finishing talking on the phone, the recipient should press the neces-
sary key to start receiving the fax.
Once the recipient's fax machine is ready, a beep is sounded.
6
Press the Start key to begin scanning and sending the fax.
7
Replace the handset to its cradle.
d
d
3-22
When sending a fax manually, load the document into the ADF. An
error will occur if the document is placed on the original glass.
For details on loading the document into the ADF, refer to "Send-
ing a Fax Using the ADF" on page 3-2.
For details, refer to "Selecting the Image Quality" on page 3-7.
The fax number of the recipient can also specified using the key-
pad in the control panel of this machine.
If Pulse is selected as the telephone line type, press the
temporarily change the line type to Tone.
To stop the transmission, press the Stop/Reset key. A message
appears, requesting confirmation to cancel the setting. Select
[YES], and then press the Select key.
If [FAX TX] in [ADMIN. MANAGEMENT]/[PASSWORD SETTING]/
[FULL FUNC. NO.] has been restricted, type in the number speci-
fied for [FULL FUNC. NO.] after pressing the Start key.
Sending a Fax Manually
key to