If Line Length Does Not Match - Canon 3433B010 Basic Manual

To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust the
amount that paper is advanced.
There are two options in Adjust Length : AdjustmentPrint and Change Settings .
• AdjustmentPrint : After a test pattern is printed, you will measure the discrepancy based on the results of
printing.
• Change Settings : No test pattern is printed. Instead, you will measure a document already printed to
determine the discrepancy.
Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/
Draft .
• A:High : This setting is applied when Highest or High is selected in Print Quality in the printer driver.
• B:Standard/Draft : This setting is applied when Standard or Draft is selected in Print Quality in the printer
driver.
• Always check the Adj. Priority values before using Adjust Length .
(→"Selecting a Feed Amount Adjustment Method (Feed Priority)," User Manual)
• Use paper of the same type and size for adjustment as you will use for printing.
Paper to
Prepare
Perform adjustment as follows.
1
Load the paper.
(→ , Attaching the Roll Holder to Rolls)
(→ , Loading Rolls in the Printer)
(→ , Loading Sheets in the Printer)
• Always make sure the loaded paper matches the type of paper specifi ed. Adjustment cannot be
completed correctly unless the loaded paper matches the settings.
2
On the Tab Selection screen of the Control Panel , press
◄ or ► to select the Settings/Adj. tab (
• If the Tab Selection screen is not displayed, press the Menu button.

If Line Length Does Not Match

Adjust the length of printed lines as follows.
• Rolls
An unused roll at least 10 inches wide
High-precision ruler
• Sheets
One sheet of unused paper of at least A4/Letter size
High-precision ruler
).
30
Ready
OK:Setting/Adj. Menu
Maint. cart.
Remaining Amount