Canon 3433B010 Basic Manual page 34

Error Messages
Error Message
GARO Wxxxx (x represents a
number)
GL2: W0502 The parameter is
out of range.
GL2: W0504 This command is
not supported.
GL2: Wxxxx The memory is
full. (xxxx is 0501, 0903, or 0904)
No ink left.
Ink insufficient.
Not much ink is left.
Unable to detect ink level
correctly.
Close Ink Tank Cover
Ink tank is empty.
Cause
There is a problem with the print
job.
A parameter specified in an HP-
GL/2 command is out of the
supported range.
The printer has received an
unsupported HP-GL/2 command.
The printer memory is full.
There is no ink left.
The ink level is low, so you cannot
print, clean the Printhead , or do
other operations that require ink.
Not much ink is left.
The remaining ink level could not
be correctly detected.
The Ink Tank Cover is open.
There is no ink left in an ink tank.
34
Corrective Action
Try printing again, using the correct printer driver.
It is also possible to continue printing in this state.
However, you may not be able to obtain the desired
printing results.
Check the print job.
If you have specified ProcessingOption > Warning >
On in the Control Panel menu, set it to Off instead.
Check the print job.
If you have specified ProcessingOption > Warning >
On in the Control Panel menu, set it to Off instead.
Because the entire print job could not be received,
the printer may not be able to print the entire original.
Check the printing results.
In the Control Panel menu, setting On-the-Fly to
On may enable printing. However, check the printing
results because the image may be incomplete in
some cases.
Open the Ink Tank Cover and replace the Ink Tank for
which the Ink Lamp is flashing.
(→ , Replacing Ink Tanks)
Press ▲ or ▼ to select Rep. Ink Tank , and then
press the OK button. Replace the Ink Tank that is low
with a new Ink Tank .
(→ , Replacing Ink Tanks)
Press ▲ or ▼ to select Continue to print , and then
press the OK button to resume printing. However,
note that this error may affect the printing quality.
Prepare a new Ink Tank .
We recommend replacing the Ink Tank with a new Ink
Tank at this point if you plan to print large-format or
high-quantity jobs.
Close the Ink Tank Cover .
The buzzer will stop once the error is cleared.
Close the Ink Tank Cover .
The buzzer will stop once the error is cleared.
Open the Ink Tank Cover and replace the Ink Tank for
which the Ink Lamp is flashing.
(→ , Replacing Ink Tanks)