Canon 3433B010 Basic Manual page 35

Error Message
No ink tank loaded.
Wrong ink tank.
Do not pull out ink tank.
Remaining level of the ink
cannot be correctly detected.
Check printed document.
Top cover is open.
Error in cutter position.
Regular printing is selected, but
a roll is loaded.
Sheet printing is selected.
Cause
There is no Ink Tank in the printer.
There is a problem with the Ink
Tank .
The Ink Tank in the printer is
incompatible.
The remaining ink level could not
be correctly detected.
Ink level detection cannot work
correctly if you use refill ink tanks.
The Printhead nozzles are
becoming clogged.
The printer has detected that the
Top Cover is open.
The Cutter Unit stops in the
middle of cutting.
A print job for printing on sheets
was sent when a roll is loaded.
You have attempted to print a test
print sheet or other printer status
information on a sheet, but no
sheet is loaded.
35
Corrective Action
Load or reload the Ink Tank .
(→ , Replacing Ink Tanks)
Replace it with a new Ink Tank .
(→ , Replacing Ink Tanks)
Load an Ink Tank specified for use with the printer.
(→ , Replacing Ink Tanks)
Install the Ink Tank that was removed.
The buzzer will stop once the error is cleared.
The refill ink tank can no longer be used. See the
section " Ink level detection " and take the appropriate
action. (→"Ink Level Detection," User Manual)
If printing is faint, clean the Printhead .
(→ , If Printing is Faint)
Open the Top Cover fully, remove any foreign objects,
and close the Top Cover again.
If the error occurs again, close the Top Cover , turn off
the printer, and wait a while before restoring power.
1. Push the Release Lever back and remove the
paper.
2. Pull the Release Lever forward.
1. Press ▲ or ▼ to select Remove Roll Paper , and
then press the OK button to stop printing.
2. After removing the roll, load and print on a sheet of
the type and size of paper you have specified in the
printer driver.
(→ , Removing the Roll from the Printer)
(→"Loading and Printing on Sheets," User Manual)
Press ▲ or ▼ to select Load Cut Sheet , and then
press the OK button. Load the sheet, and then print.
(→"Loading and Printing on Sheets," User Manual)
To print on rolls, follow these steps.
1. Press ▲ or ▼ to select Stop Printing , and then
press the OK button to stop printing.
2. Load a roll and try printing again.
(→"Loading and Printing on Rolls," User Manual)
Error Messages