Traffic Engineering - Cisco 7246VXR - uBR Router Software Configuration Manual

DOCSIS and CMTS Interoperability

Traffic Engineering

Sending data reliably upstream is a critical issue. Designing a robust upstream architecture requires
balancing system parameters, establishing subscriber data requirements, and configuring the network to
support those requirements.
Upstream spectrum varies greatly between cable plants. Maintaining stable return paths also differs
based on varying patterns and levels of ingress noise and interference. Common problems in cable plants
include:
•
•
•
•
•
•
•
•
•
•
•
•
When configuring your system, configure downstream and upstream parameters based on the fiber nodes
involved, the required services the cable modem or STB supports, the importance of the data, and desired
performance capabilities.
Your cable plant determines its data performance. Design your network to maximize its performance and
capacity at minimum cost, while meeting subscriber data requirements. Select or customize upstream
profiles for maximum trade-offs between bandwidth efficiency and upstream channel robustness once
you're familiar with the system and have characterized your network. For example, QAM-16 requires
approximately 7 dB higher C/N ratio to achieve the same bit error rate (BER) as QPSK, but it transfers
information at twice the rate of QPSK.
Note Older plants and plants with long amplifier cascades are more susceptible to ingress than newer plants.
These plants produce more noise and signal level variances.
Cisco recommends you keep input to all amplifiers at the same power level in the upstream direction and
Tip
keep output of all amplifiers in the downstream direction at the same power level. This is called unity
gain. Tune amplifiers and other equipment properly at desired frequencies. To characterize and improve
your cable plant's stability, follow procedures in the
Hardware Installation Guide
A DOCSIS cable plant has the following groups of traffic to size based on current service offerings:
•
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
1-142
Electrical and magnetic interference (EMI)
Thermal noise
Carrier to noise (C/N) imbalances
Interference of leaking signals
Ingress due to other channels appearing at the desired channel frequency
Distortion due to non-linearities of cable equipment
Cross modulation—carrier to frequency distortion
Hum and low frequency distortion
Improper RF amplifier tuning
Non-unity gains due to incorrect usage of attenuators
Low-quality subscriber equipment
Out of range signal power from the CMTS to the cable modem
Basic Internet access data, which is burst-intensive and asymmetrical; asymmetrical traffic supports
a larger data rate in one direction—the downstream.
Cisco uBR7200 Series Universal Broadband Router
on Cisco.com.
Chapter 1 Overview of Cisco uBR7200 Series Software
OL-2239-05