Cisco 7246VXR - uBR Router Software Configuration Manual page 39

Chapter 1 Overview of Cisco uBR7200 Series Software
The follow example illustrates the show interfaces command with status information (including the
physical port adapter number) for each port adapter and cable interface card in the Cisco uBR7246 router:
Router# sh int
FastEthernet0/0 is administratively up, line protocol is up
Hardware is DEC21140, address is 0000.0000.0000 (bia 0000.0000.0000)
Internet address is 1.1.1.3
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
(display text omitted)
Hssi1/0 is administratively down, line protocol is down
Hardware is MIF68840_MM, address is 0000.0000.0000 (bia 0000.0000.0000)
Internet address is 1.1.1.0
MTU 4470 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
(display text omitted)
Ethernet2/0 is administratively up, line protocol is up
Hardware is AmdP2, address is 0000.0000.0000 (bia 0000.0000.0000)
Internet address is 1.1.1.7
MTU 1500 bytes, BW 100000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
(display text omitted)
Cable3/0 is up, line protocol is up
Hardware is CMTS, address is 0009.0ed6.ee18 (bia 0009.0ed6.ee18)
Internet address is 1.1.1.1/24
MTU 1500 bytes, BW 27000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
(display text omitted)
You can also use arguments such as the interface type (Ethernet, Fast Ethernet, ATM, serial, HSSI,
Packet-over-SONET, and so forth) and the port address (slot/port) to display information about a specific
port adapter interface only. The following example shows such a display:
Router# sh int f1/0
FastEthernet1/0 is up, line protocol is up
Hardware is AmdFE, address is 0030.7bfa.a81c (bia 0030.7bfa.a81c)
Internet address is 111.0.1.18/30
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output 00:00:02, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
OL-2239-05
reliability 255/255, txload 1/255, rxload 1/255
0 packets put, 230925 bytes
Received 146107 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
0 packets put, 284529 bytes, 0 underruns
0 output errors, 0 collisions, 10 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
Cisco uBR7200 Series Router Configuration Overview
1-21