Cisco 7246VXR - uBR Router Software Configuration Manual page 181

Chapter 2 Configuring the Cable Modem Termination System for the First Time
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
4 Serial network interface(s)
4 Cable Modem network interface(s)
125K bytes of non-volatile configuration memory.
125440K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
4096K bytes of Flash internal SIMM (Sector size 256K).
cable submgmt default active
Press RETURN to get started!
The first two sections of the configuration script, the banner and the installed hardware, appear only at
Note
initial system startup. On subsequent uses of the Setup facility, the script begins with the following
prompt.
Continue with configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
When asked if you want to continue with the System Configuration dialog and enter basic management
Step 3
setup (displays the current interface summary), enter yes or press Return:
Continue with configuration dialog? [yes/no]: yes
.
.
.
Would you like to enter basic management setup? [yes/no]: yes
The interface summary appears, showing the state of configured and unconfigured interfaces.
Choose which protocols to support on your interfaces. For IP-only installations, you can accept the
Step 4
default values for most of the questions. A typical configuration using IP follows and continues through
Step
Configuring global parameters:
Enter host name [Router]: router
Enter the enable secret password, the enable password, and the virtual terminal password:
Step 5
The enable secret password is a one-way cryptographic secret
password used instead of the enable password when it exists.
Enter enable secret: ******
The enable password is used when there is no enable secret
password and when using older software and some boot images.
Enter enable password: ******
Enter virtual terminal password: ******
OL-2239-03
--- System Configuration Dialog ---
7:
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
Configuring the Cisco uBR7200 Series Using the Setup Facility
2-19