Cisco 7246VXR - uBR Router Software Configuration Manual page 93

Chapter 1 Overview of Cisco uBR7200 Series Software
cops ip dscp
To specify the marking for COPS messages that are transmitted by the Cisco router, use the cops ip dscp
command in global configuration mode. To remove this configuration, use the no form of this command.
Syntax Description x
Defaults
•
•
Usage Guidelines
•
•
•
OL-2239-05
cops ip dscp x
no cops ip dscp
This value specifies the markings with which COPS messages are transmitted. The
following values are supported:
0-63—DSCP value ranging from 0-63.
•
af11—Use AF11 dscp (001010)
•
af12—Use AF12 dscp (001100)
•
af13—Use AF13 dscp (001110)
•
• af21—Use AF21 dscp (010010)
af22—Use AF22 dscp (010100)
•
af23—Use AF23 dscp (010110)
•
af31—Use AF31 dscp (011010)
•
• af32—Use AF32 dscp (011100)
af33—Use AF33 dscp (011110)
•
af41—Use AF41 dscp (100010)
•
af42—Use AF42 dscp (100100)
•
af43—Use AF43 dscp (100110)
•
• cs1—Use CS1 dscp (001000) [precedence 1]
cs2—Use CS2 dscp (010000) [precedence 2]
•
cs3—Use CS3 dscp (011000) [precedence 3]
•
cs4—Use CS4 dscp (100000) [precedence 4]
•
• cs5—Use CS5 dscp (101000) [precedence 5]
cs6—Use CS6 dscp (110000) [precedence 6]
•
cs7—Use CS7 dscp (111000) [precedence 7]
•
default—Use default dscp (000000)
•
ef—Use EF dscp (101110)
•
For messages transmitted by the Cisco router, the default DSCP value is 0.
For incoming connections to the Cisco router, by default, the COPS engine takes the DSCP value
used by the COPS server that initiates the TCP connection.
The cops ip dscp command allows the Cisco router to re-mark the COPS packets for either incoming
or outbound connections.
This command affects all TCP connections with all COPS servers.
This command does not affect existing connections to COPS servers. Once you issue this command,
this function is supported only for new connections after that point in time.
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
cops ip dscp
1-75