Cisco 7246VXR - uBR Router Software Configuration Manual page 170

Configuration Fundamentals for the Cisco uBR7200 Series
If Break is enabled, the router enters the ROM monitor, indicated by the ROM monitor prompt
•
(
rommon n>
If Break is disabled, power cycle the router (turn the router off or unplug the power cord, and then
•
restore power). Proceed to Step 5.
Within 60 seconds of restoring the power to the router, press the Break key or send a Break. This action
Step 5
causes the router to enter the ROM monitor and display the ROM monitor prompt (
To set the configuration register on a Cisco uBR7200 series router, use the configuration register utility
Step 6
by entering the confreg command at the ROM monitor prompt as follows:
rommon 1> confreg
Answer yes to the enable
register settings.
Step 7 Initialize the router by entering the reset command as follows:
rommon 2> reset
The router initializes, the configuration register is set to 0x142, the router boots the system image from
Flash memory and enters the System Configuration dialog (setup), as follows:
--- System Configuration Dialog --
Step 8 Enter no in response to the System Configuration dialog prompts until the following message appears:
Press RETURN to get started!
Step 9 Press Return. The user EXEC prompt appears as follows:
Router>
Enter the enable command to enter privileged EXEC mode.
Step 10
Enter the show startup-config command to display the passwords in the configuration file as follows:
Step 11
Router# show startup-config
Scan the configuration file display looking for the passwords; the enable passwords are usually near the
Step 12
beginning of the file, and the console login or user EXEC password is near the end. The passwords
displayed will appear similar to the following:
enable secret 5 $1$ORPP$s9syZt4uKn3SnpuLDrhuei
enable password 23skiddoo
.
.
line con 0
password onramp
The enable secret password is encrypted and cannot be recovered; it must be replaced. The enable and
Note
console passwords can be encrypted text or clear text.
Proceed to the next step to replace an enable secret, console login, or enable password. If there is no
enable secret password, note the enable and console login passwords if they are not encrypted and
proceed to
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
2-8
), where n is the number of the command line. Proceed to Step 6.
ignore system config info?
Step 17.
Chapter 2 Configuring the Cable Modem Termination System for the First Time
prompt and note the current configuration
).
rommon 1>
OL-2239-03