Cisco 7246VXR - uBR Router Software Configuration Manual page 54

Supported Software Features for the Cisco uBR7200 Series
Cisco IOS Release 12.3(9a)BC Command-Line Interface (CLI) Enhancements
Cisco IOS Release 12.3(9a)BC supports the following new or enhanced command-line interface:
•
•
•
•
•
For additional information about these command changes, refer to this document on Cisco.com:
•
cable logging layer2events
To save DOCSIS events that are specified in Cable Device MIB to the cable logging buffer (instead of
to the general logging buffer), use the cable logging layer2events command in global configuration
mode. To disable the logging of DOCSIS events to the cable logging buffer, use the no form of this
command.
Syntax Description
This command has no additional arguments or keywords.
Defaults DOCSIS events are saved to the general logging buffer on the Cisco CMTS by default.
Command Modes Global configuration mode
Command History Release
12.3(9a)BC
Usage Guidelines Use the show cable logging command to check whether the logging feature is enabled and the status of
the logging buffer.
Examples
The following example shows how to clear the log buffer that contains a bad IP source address error
messages:
Router# show cable logging summary
Cable logging: BADIPSOURCE Enabled
Total buffer size (bytes): 1000000
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
1-36
cable logging layer2events, page 1-36
cable source-verify, page 1-37
show cable tech-support, page 1-41
show controllers cable, page 1-42
show tech-support, page 1-44
CiscoIOS CMTS Cable Command Reference Guide
http://www.cisco.com/en/US/docs/ios/cable/command/reference/cbl_book.html
cable logging layer2events
no cable logging layer2events
Modification
This command was introduced on the Cisco uBR10012 and
Cisco uBR7246VXR universal broadband routers.
Chapter 1 Overview of Cisco uBR7200 Series Software
OL-2239-05