Cisco 7246VXR - uBR Router Software Configuration Manual page 55

Chapter 1 Overview of Cisco uBR7200 Series Software
Used buffer size (bytes) : 36968
Logged messages : 231
Router# clear cable logging badipsource
Router# show cable logging summary
Cable logging: BADIPSOURCE Enabled
Total buffer size (bytes): 1000000
Used buffer size (bytes) : 0
Logged messages : 0
Related Commands Command
cable logging badipsource
show cable logging
For additional information about logging events on the Cisco CMTS, refer to the following document on
Cisco.com:
•
cable source-verify
To enable verification of IP addresses or service IDs (SIDs) for CMs and CPE devices on the upstream,
use the cable source-verify command in global configuration, cable interface configuration or
subinterface configuration modes. To disable verification, use the no form of this command.
Cable Interface and Subinterface Configuration Modes
Global Configuration Mode
OL-2239-05
Cisco IOS CMTS Cable Command Reference Guide
http://www.cisco.com/en/US/docs/ios/cable/command/reference/cbl_book.html
cable source-verify [dhcp | leasetimer value | leasequery-filter upstream query-num interval]
no cable source-verify
cable source-verify leasequery-filter downstream query-num interval
no cable source-verify
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
Supported Software Features for the Cisco uBR7200 Series
Description
Logs error messages about bad IP source addresses on the cable
interfaces to a separate log buffer,
Indicates whether the logging feature is enabled and the status of the
logging buffer.
1-37